Comments on: insulation for fish hold? http://www.nrfoam.org/high-density-foam/insulation-for-fish-hold/ Wed, 17 Mar 2010 10:13:59 +0000 hourly 1 http://wordpress.org/?v=3.2.1 By: Vernal H http://www.nrfoam.org/high-density-foam/insulation-for-fish-hold/#comment-1079 Vernal H Sun, 22 Nov 2009 02:43:59 +0000 http://www.nrfoam.org/high-density-foam/insulation-for-fish-hold#comment-1079 lay down the block but leave about a one inch gap between the blocks.cover gaps with duct tape. at the lowest points and highest punch small hole in tape. use cans of foam to fill spaces starting at the bottom (left side or right side) when foam comes out top hole plug it.<br><b>References : </b><br> lay down the block but leave about a one inch gap between the blocks.cover gaps with duct tape. at the lowest points and highest punch small hole in tape. use cans of foam to fill spaces starting at the bottom (left side or right side) when foam comes out top hole plug it.
References :

]]> By: Peter J http://www.nrfoam.org/high-density-foam/insulation-for-fish-hold/#comment-1078 Peter J Sun, 22 Nov 2009 02:18:59 +0000 http://www.nrfoam.org/high-density-foam/insulation-for-fish-hold#comment-1078 It should retain insulating properties, cement conducts heat, but much less than steel or aluminum. If most of the surface area is the foam, you should be okay from an insulating standpoint. The concern I would have is excess condensation from places where the insulation is less. I'd suggest trying something similar on a small scale before modifying the boat. (Perhaps making a two-foot square model of what you're attempting. You could use dry ice to get the internal temperature cold enough to imitate what you're trying to do.)<br><b>References : </b><br> It should retain insulating properties, cement conducts heat, but much less than steel or aluminum. If most of the surface area is the foam, you should be okay from an insulating standpoint.

The concern I would have is excess condensation from places where the insulation is less. I’d suggest trying something similar on a small scale before modifying the boat. (Perhaps making a two-foot square model of what you’re attempting. You could use dry ice to get the internal temperature cold enough to imitate what you’re trying to do.)
References :

]]>